User's Manual

Firmware update
116
18.2.2 Work step 2: Transfer and run the update-file
Proceed as follows:
Step Description
1
In the Correlator main menu, tap the button .
2 In the displayed menu, tap the Firmware update / Service button.
3
In the displayed menu, tap the
Firmware update: Power transmitter
button if you want to update one or
more Power transmitters.
In the displayed menu, tap the
Firmware-Update: Multi sensor button
if you want to update one or more
Multi sensors.
Result: The following menu opens:
In the display area, the update-file is shown which is temporarily stored in the
Correlator root directory.
If more than one file is listed, select the required one.
If no file is displayed, there is no firmware update-file in the root directory. Perform
again "Work step 1" (see page 115) in order to download the relevant file.
4
2 options
Updating one individual
Power transmitter or one Multi sensor
Updating all Power transmitters or
all Multi sensors which are registered to
the Correlator.
Tap the Select device button. Tap the Update all devices button
(for the next steps, go to the paragraph
"Updating a single device")
(for the next steps, go to the paragraph
"Updating all devices")
update-file