User's Manual

Query the status of a device
111
17 Query the status of a device
By means of the Read configuration function you have the possibility to obtain
information on the current configuration, the identity and the state of a Power transmitter
or Multi sensor. The information is retrieved from the relevant device using the
Correlator.
The following requirements must be met:
• The relevant sensor must be switched on.
• The sensor must be within the Correlator's radio range.
Proceed as follows:
Step Description
1
If you want to read a Power transmitter,
use the arrow buttons in the Start menu
to go to an Online measuring mode, e.g.
"COR PT-3 with microphone".
If you want to read a Multi sensor,
use the arrow buttons in the Start menu
to go to an Offline measuring mode, e.g.
"COR MS-3 with microphone".
2
In the main menu, tap the button .
3 In the displayed menu, tap the Tools button.
4 In the displayed menu, tap the Read configuration button.
Result: A new menu opens. The up to 8 fields displayed represent the
Power transmitters and Multi sensors registered in the Correlator's sensor pool.
5
Tap on the field of the sensor which you want to read.
6 In the displayed menu, tap the Read button.
Result: A connection is established between the Correlator and the device. After
transfer, the data is displayed on the screen.
The display shows a lot of information reflecting the status of the device. However,
much of the data is only relevant for SebaKMT service technicians in case of a problem.
The following information may be of interest to the user:
Line Description
Selected ID
Type and identification number of the sensor
Sensor number
Number of this sensor in the sensor pool
(continued on next page)
Requirements
Procedure
View