User's Manual

The Multi sensors
51
6.5 Installation
The Multi sensors should be installed directly on the pipe but, however, you can also
attach them to valve rods or hydrants, for example, or any other position along the
pipeline that is easily accessible. Due to their powerful magnet, the sensors can also be
attached horizontally to ferromagnetic surfaces.
There must be the best possible contact between the sensor foot or the mounted
adapter (see below) and the pipe. If need be, clean the contact point thoroughly
(preferably with a wire brush).
6.6 Adapter
The magnetic foot of the Multi sensor can be unscrewed and replaced by another
adaptor, e.g. by the optional magnetic angled adaptor.