User's Manual

Offline measurement - Multipoint correlation with preprogrammed sensors
57
8 Offline measurement - Multipoint correlation with preprogrammed
sensors
A group of 2 to 8 sensors is programmed for measurement and then deployed at the
measuring points. Multi sensors and/or Power transmitters can be used. The
measurement is carried out by all sensors simultaneously. During the measurement,
there is no contact between the sensors or between the sensors and the Correlator.
After the measurement, the sensors are collected and the recorded data is read, then
correlations can be carried out and displayed on the Correlator.
x Is there a digital or printed pipe network plan of the relevant measuring area with
all pipe parameters?
x Are the batteries of the relavant devices charged?
x If Power transmitters will be used: Are the microphones properly connected?
Add all the required sensors to the Correlator's Multi sensor pool:
Step Description
1
In the Start menu, navigate to the required Offline measuring mode using the
arrow buttons.
2
In the main menu, tap the button .
3 In the displayed menu, tap the Sensor management button.
4 In the displayed menu, tap the Edit/Manage button.
5
Use the displayed menu to register all sensors which are to be used.
If Power transmitters are to be used, they have to be added here as well.
A maximum of 8 sensors is possible.
6 Use the ESC pushbutton to return to the Start menu.
Checklist
prior to measurement
Registering sensors