User's Manual

The Multi sensors
50
6.3 Power supply
The Multi sensors are fitted with internal rechargeable Li-Ion batteries which can power
the devices for at least 16 hours.
In the Start menu of the correlator up to eight battery icons can be seen. They indicate
the current battery status of the registered Multi sensors in reach. To know the exact
battery state of a Multi sensor, read the unit's configuration and see the Battery level
line in the respective menu.
When the battery level of a Multi sensor falls below a certain threshold, the indicator
light of the device will blink red. The unit must then be recharged, otherwise it switches
itself off automatically.
The Multi sensors are charged wirelessly in the transport case.
As soon as the sensors are situated at their storage places in the case, they are
recharged inductively, provided the case is connected to mains or to a 12 Volt vehicle
power supply.
Charging takes approximately 6 hours. The units' indicator lights are rapidely flashing
during the process. The indicator lights turn to permanent green light as soon as the
battery is full.
CAUTION
No objects must be put into empty charging stations.
Risk of fire due to the induction !
The charging stations are for transport and charging of the
Multi sensors only.
NOTE
In order to guarantee the devices' water and dirt resistance, any repairs
must be carried out by SebaKMT or an authorised service partner.
Do not open a Multi sensor yourself. If you have problems with the battery,
please contact your SebaKMT service partner.
6.4 Switching ON/OFF
The Multi sensors have an internal magnetic switch.
To turn a Multi sensor on, briefly hold a magnet (e.g. the foot of another Multi sensor) in
front of the sensor's I/O area . The device turns on. The indicator light flashes
3times.
To turn the device off, hold a magnet in front of the I/O area for approximtely 2 sconds.
The indicator light will flash 2 times before it goes out.
Battery level
Charging