Seaward Products LPG GAS STOVES OWNER'SMANUAL FOR GAS OPERATED .
LPG FUEL TANK INST4LLATION REFERENCE: STANDARD #A-1 AMERICANBOAT & YACHT COUNCIL 3069 SOLOMON'S ISLAN[j~OAD EDGEWATER, MD 23037 ~ ~;- LPG TANK WITH REGULATION SYSTEM 1. Locate the tank and regulator system on deck, cabjn top or in a vapor tight compartment, insulated from the hull interior and protected from climatic extremes by a housing vented to the open air.
REGULATION SYSTEM CONNECTING FITTING RELIEF VALVE ASME LPG FUEL -TANK APPLIANCE FUEL HOSE CONNECTION SUMMARY FOR CHECKING LPG SYSTEM AND LPG APPLIANCE 1. After the LPG tank has been installed, the regulation system connected, the hose run and connected to both the appliance and the regulator, slowly crack open the LPG tank valve and observe the pressure gauge on the regulation system. The gauge should read approximately 110 psi at 70°F. (Higher if warmer, or lower if cooler atmospheric temperature.
GIMBALEDMODELS - 2 & 3 BURNERS 1. It is important that the following minimum clearances when installing your gimbaled range. from combustible materials be adhered to 2 BURNERMODEL:Side - 7" minimum as measured from the center line of the closest burner head. Rear. 9" minimumas measured from the center line of the closest burner head. Top - 24" minimumto overhead cabinets, shelves or any other combustible material. 3 BURNER MODEL: Side.
2 BURNER STOVE WITH OVEN. . . DIMENSIONS AND GIMBAL INSTALLATION r~ l7~4 - t--~' --+--t . . . --+-I 22.e I I-st-! I I r 18it " I~~ -2Ii".,. -vi .
STOVEWITHOVEN.. . 3 BURNER DIMENSIONSAND GIMBALINSTALLATION -4 r-/t 0 ~QQ~ ttrf: ~l/t~ I~ . . .. ~11. " --LL t--1/<1 2~ - fffJ.A I / 5" "I' f, ",." /" 17-7r; li~ -21)-10 V! z-t-l I-- 7-i--! l ~ -18~ 247/16 uuiurr- f - - \ i\\ IS9. \. \\ j"ik r", ,;Iz. IIf 13\ ,.,i I- 12t - l.
CARE AND CLEANING 2 BURNER STOVE WITH OVEN. . . BUilT-IN INSTALLATION Regular cleaning with a soft cloth and a warm detergent solution is generally enough to keep your oven clean and beautiful. This is done when the range is cool. Use a dry cloth or paper towel to clean splatters and spills when surfaces are warm. PORCELAIN ENAMEL Porcelain enamel is glass fused on steel at very high temperatures. It is not extremely delicate, but must be treated as glass.
OPERATING INSTRUCTIONS 1. LPG STOVE It is recommended that every time the LPG tank valve is opened for use, the operator close the valve and that the gauge needle remains constant. watch 2. If leaks occur, correct. If leaks cannot be corrected, do not operate appliance. 3. Always test light a top burner after opening the tank valve to dispose of air in the supply line. This could be caused by someone's opening the system to fill a LPG tank or by opening a burner valve.
OPERATING INSTRUCTIONS SUMMARY FOR A LPG SYSTJ:M 1. Close tank valve immediately in any emergency. 2. Be sure all appliance valves are closed before opening tank valve. 3 Always apply lit match or other flame to burner before opening burner valve. 4. Close tank valve whenever appliance is not in use. 5. Test system for leakage Ihe following procedure: at least twice a month and a(ter any emergency in accordance with WITH APPLIANCE VALVES CLOSED AND WITH TANK VAlV~ OPEN, NOTE PRESSURE ON GAUGE.
EXPLODED VIEW AND PARTS LISTS OF ALL GAS STOVES WITH OVENS MODELS: 2172, 2372/3172, 3372 EFGHIJKlMN I. 2-- '."-..- 3-.. 5 67-89-10-11- 12-.'" 0 -----.. -.---.-..- -- -. U'--- MODELS: 2172, ITEMNO. A. B. C. D. PARTNO. 73389 72419 73976 70507 DESCRIPTION Faceplate 2BR 100% Gas Lighter 100% BurnerValve Hood,Top BurnerValve E. F. G. H. I. 72540 72199 72547 73392 73972 2372, Burner,Front Left Bezel Safety, Pilot Fuel Line Fuel Line 9 J. K M. N.
2 BURNER GAS STOVE WITH OVEN ITEM NO. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. 27. 28. 29. 30. 31. 32. 33. 34. 35. 36. 37. 38. 39. 40. 41. 42. 43. 44. 45. 46. 47. 48. 49. 50. 51. 52. 53. 54. 55. 80011 80010 ITEM NO. A. B. C. D. E. PART NO.
LIMITED TWO YEAR WARRANTY SEAWARDPRODUCTSwarrantsthe productsdeliveredwillbe:A.freefrom(1)encumbrancesand (2) defects in material and workmanship under the normal use and service, and B. will meet applicable specifications and descriptions at time of delivery to BUYER. The obligationof SEAWARDunderthis Warrantyis limitedto the repair,rework,or replacement,at SEAWARD'Soption, any part or component thereof, which examination discloses to our satisfaction to have been nonconformingor defective.
