User's Manual

GB
BEFREE X1 RADIO CONTROL
The radio control in the BeFree x1 series can be used
to control (Up – Stop – Down) user commands.
Codes are transmitted using an 18-bit random
system, which can be used in conjunction with other
transmitters in the same series and may be integrated
perfectly with SEAV receivers and electronic control
units.
- Mod. BeFree S1: 433.92 MHz
- Mod. BeFree H1: 868.30 MHz
TECHNICAL DATA
- Alkaline battery powered : 12 V mod. 23 A
- Operating frequency : see model
- Combinations : 32768
- Max. consumption : 25 mA
- Operating temperature : -10 to + 70 °C
- Dimensions : 120 x 45 x 15 mm.
O
PERATING DESCRIPTION
The radio control has 3 command buttons - UP, STOP
and DOWN - and an indicator LED. The LED flickers
when a transmission code is being sent.
INITIAL OPERATING CONDITION
The radio control is supplied by the manufacturer with
default random codes.
OPERATING MODES
Creating a new random code (Reset):
The radio control is supplied by the manufacturer with
default random codes. If you want to create a new set
of random codes, perform the RESET procedure as
follows: press and hold the UP, STOP and DOWN
buttons simultaneously for 2 seconds. After the LED
lights up, press the UP and DOWN buttons within 5
seconds. The LED will flash 3 times to indicate that
the process is complete.
WARNING
! The RESET procedure completely
deletes the default codes.
Copying all the information contained in the radio
control:
It is only possible to copy all the transmission codes
on the radio control if the products are the same
model.
To copy all the information between radio controls,
proceed as follows: connect the two radio controls
using the cable supplied as an “optional extra”; press
and hold any button on the
source radio control for 2
seconds. The LED on the
destination radio control
the information will flash 3 times to indicate that the
operation is complete.
WARNING
! The default configuration of the radio
control has no password protection; it is therefore
possible to copy all information. If the radio control is
supplied with a password enabled it will not be
possible to carry out the copying process.
Other functions using a PC:
The radio control can be connected to a Personal
Computer using the “SW 2188” software package
which is supplied as an optional extra and enables
you to utilise further functions.
Other functions using a Programmer:
The radio control can be connected to a “PGM 2191”
portable Programmer which is supplied as an optional
extra and enables you to utilise further functions.
WARNING
− The battery should be replaced every year to
guarantee the optimal range of the transmitter.
− To replace the exhausted battery, take the plastic
lid off, remove the battery and replace it with a new
one, observing the correct battery polarities.
− Used batteries should be discarded in special
collection bins.
SEAV s.r.l. hereby declares that the below product:
BeFree Series Radio Control
complies with the specifications set out in the
Directive R&TTE 99/5/EC.
-1- Rev. 2.0 27 April 2007