User manual

SeaSTAR 3100LRS USER MANUAL
Issue 1.0 08/02
34
Autoscan Menu
Autoscan is a special feature, which allows the 3100LRS Receiver’s to
automatically search for another satellite signal to use. This feature only starts
if it is enabled and if the receiver cannot lock the current satellite signal for the
period specified in the Wait Lock menu (default is 60 seconds). The receiver
has an internal table of possible services and attempts to lock onto the most
appropriate service for the period specified in the Wait Scan menu. If it
succeeds it continues to use this service. Otherwise another service is selected
and the process is repeated until a successful service is found or the original
service comes back on-line. During the autoscan process, the receiver’s menu
displays “Autoscan …” on the top line and the service it is currently scanning
on the bottom line.
By pressing the ⇒ key the following
sequence occurs. Pressing the ⇐ key
gives the same fields in reverse.
Autoscan enabled This menu item
allows the autoscan feature to be
selectively enabled and disabled.
Change the Autoscan enabled state by
pressing the up and down arrows, then
press the centre button. The display will
briefly flash “INPUT ACCEPTED”.
Wait Lock This is the length of time the
receiver must be without a DGPS signal
before the Autoscan feature begins to
search for a new satellite service.
Change the wait lock using the up and
down arrows, then press centre button
before moving on to the wait scan -
The display will briefly flash “INPUT
ACCEPTED”
A
utoscan Contrl ...
RECV →
A
utoScan On? N
RECV →
Wait Lock = 00060sec
RECV →
FSPAS Ref.: B31005102PMBRA0