User manual
Table Of Contents
- Front cover
- CAUTION
- IMPORTANT SAFETY INSTRUCTIONS
- Canadian Compliance
- Software License
- Copyright
- CONTENTS
- INTRODUCTION
- BASIC OPERATION
- AUDIO/VIDEO CONNECTIONS
- RF BYPASS
- OPTIMIZING YOUR DCT* OUTPUT SETTINGS
- User Options
- CONNECTING YOUR DCT*
- CONNECTING YOUR DCT* TO A HDTV – VIDEO ONLY
- CONNECTING YOUR DCT* TO A HDTV – AUDIO ONLY
- CONNECTING YOUR DCT* TO AN A/V RECEIVER – AUDIO ONLY
- CONNECTING YOUR DCT* TO A STEREO TV
- CONNECTING YOUR DCT* TO A STEREO TV AND STEREO VCR
- CONNECTING YOUR DCT* TO AN A/V RECEIVER, TV, AND VCR
- CONNECTING YOUR DCT* TO A STEREO TV, VCR, AND DVD
- RECORDING YOUR CONNECTIONS
- GRAPHICS OVERLAYING THE VIDEO
- DATA DEVICES
- TROUBLESHOOTING
- The DCT* will not power on
- The remote control does not work
- There is no audio when viewing cable channels
- There is no audio from the center and/or surround speakers of a home theater receiver connected to the DCT*
- There is no video on the TV screen
- There are no graphics, closed captions, or program guides appearing on the TV screen
- There are black bars to the right and left of the picture
- There are black bars above and below the picture
- There are black bars on all four sides of the picture
- SPECIFICATIONS
- Back Cover

36
Problem Possible Solution
There is no audio
when viewing cable
channels
Verify that the MUTE button on the DCT* or the remote
control has not been pressed. Press MUTE on the remote
control to restore sound.
If the DCT* audio output is connected to the TV, verify
that the
MUTE button on the TV has not been pressed.
If the DCT* audio output is connected to a home theater
receiver, verify that the receiver is set to the appropriate
input source and the mute button on the receiver has not
been pressed.
Verify that you have the correct cables for the audio
ports.
Verify that the audio cables are firmly connected
between the DCT* and the audio playback device (TV,
receiver, etc.).
There is no audio
from the center
and/or surround
speakers of a home
theater receiver
connected to the
DCT*
Not all Dolby Digital programs feature full 5.1 surround
sound. In some cases, the programs may only contain
left and right stereo audio.
Verify that the SPDIF cable (coaxial or optical) is firmly
connected to the DCT* and the home theater receiver.
Verify that the home theater receiver is set to a surround
sound audio mode (Dolby Digital, Dolby Pro Logic II,
Dolby Pro Logic).
Verify that the receiver is properly configured to work
with all connected speakers.