User manual
Table Of Contents
- Front cover
- CAUTION
- IMPORTANT SAFETY INSTRUCTIONS
- Canadian Compliance
- Software License
- Copyright
- CONTENTS
- INTRODUCTION
- BASIC OPERATION
- AUDIO/VIDEO CONNECTIONS
- RF BYPASS
- OPTIMIZING YOUR DCT* OUTPUT SETTINGS
- User Options
- CONNECTING YOUR DCT*
- CONNECTING YOUR DCT* TO A HDTV – VIDEO ONLY
- CONNECTING YOUR DCT* TO A HDTV – AUDIO ONLY
- CONNECTING YOUR DCT* TO AN A/V RECEIVER – AUDIO ONLY
- CONNECTING YOUR DCT* TO A STEREO TV
- CONNECTING YOUR DCT* TO A STEREO TV AND STEREO VCR
- CONNECTING YOUR DCT* TO AN A/V RECEIVER, TV, AND VCR
- CONNECTING YOUR DCT* TO A STEREO TV, VCR, AND DVD
- RECORDING YOUR CONNECTIONS
- GRAPHICS OVERLAYING THE VIDEO
- DATA DEVICES
- TROUBLESHOOTING
- The DCT* will not power on
- The remote control does not work
- There is no audio when viewing cable channels
- There is no audio from the center and/or surround speakers of a home theater receiver connected to the DCT*
- There is no video on the TV screen
- There are no graphics, closed captions, or program guides appearing on the TV screen
- There are black bars to the right and left of the picture
- There are black bars above and below the picture
- There are black bars on all four sides of the picture
- SPECIFICATIONS
- Back Cover
DCT6200/DCT6208 User Guide
35
TROUBLESHOOTING
Before calling your service provider, review this troubleshooting guide.
This information is to help you quickly solve a problem. If your problem
still exists, contact your service provider.
Problem Possible Solution
The DCT* will not
power on
Verify that the AC power cord is connected to the DCT*
and an AC outlet.
If the DCT* is connected to a switched outlet on another
unit, verify that that unit is powered on.
Press the
POWER button on the DCT* front panel instead
of the remote control. The batteries in the remote control
may be depleted.
The DCT* may have received a software update and
may not power on while the new software is being
installed. Try again in a few minutes.
The remote control
does not work
Verify that the remote control is in “Cable” mode.
Verify that there are no obstructions between the remote
control and the DCT*. Aim the remote control directly at
the DCT* front panel, not the TV or VCR.
The angle between the remote control and the DCT*
may be too large. Stand in front of the DCT* and not too
far to either side.
Press and release operation keys one at a time, firmly
and deliberately.
Try changing channels using the buttons on the DCT*
front panel.
Check the batteries in the remote control. Install new
batteries if needed.