User manual
Table Of Contents
- Front cover
- CAUTION
- IMPORTANT SAFETY INSTRUCTIONS
- Canadian Compliance
- Software License
- Copyright
- CONTENTS
- INTRODUCTION
- BASIC OPERATION
- AUDIO/VIDEO CONNECTIONS
- RF BYPASS
- OPTIMIZING YOUR DCT* OUTPUT SETTINGS
- User Options
- CONNECTING YOUR DCT*
- CONNECTING YOUR DCT* TO A HDTV – VIDEO ONLY
- CONNECTING YOUR DCT* TO A HDTV – AUDIO ONLY
- CONNECTING YOUR DCT* TO AN A/V RECEIVER – AUDIO ONLY
- CONNECTING YOUR DCT* TO A STEREO TV
- CONNECTING YOUR DCT* TO A STEREO TV AND STEREO VCR
- CONNECTING YOUR DCT* TO AN A/V RECEIVER, TV, AND VCR
- CONNECTING YOUR DCT* TO A STEREO TV, VCR, AND DVD
- RECORDING YOUR CONNECTIONS
- GRAPHICS OVERLAYING THE VIDEO
- DATA DEVICES
- TROUBLESHOOTING
- The DCT* will not power on
- The remote control does not work
- There is no audio when viewing cable channels
- There is no audio from the center and/or surround speakers of a home theater receiver connected to the DCT*
- There is no video on the TV screen
- There are no graphics, closed captions, or program guides appearing on the TV screen
- There are black bars to the right and left of the picture
- There are black bars above and below the picture
- There are black bars on all four sides of the picture
- SPECIFICATIONS
- Back Cover
32
GRAPHICS OVERLAYING THE VIDEO
The DCT* can generate graphics that overlay the video programming or
fill the entire television screen. Common examples include on-screen
menus (such as the User Setting menu), closed captions, and interactive
program guides. The DCT* overlays these graphics whenever you open
a menu, enables closed captions, or scrolls through a program grid.
Overlaying graphics are not available on all DCT* video output and mode
combinations. The following table summarizes the availability of
overlaying graphics for each DCT* video output combination:
DCT6200 Secondary Video Output DVI or
YPbPr
Output
Mode
DCT6200
Primary Video
Output
(DVI or YPbPr)
S-Video Out
Composite
Out
RF Out
1080i
Graphics overlay
supported
Video only Video only Video only
720p
Graphics overlay
supported
Video only Video only Video only
480p
Graphics overlay
supported
Video only Video only Video only
480i
Graphics overlay
supported
Graphics
overlay
supported
Graphics
overlay
supported
Graphics
overlay
supported
The 4:3 Override feature enables you to specify a different Output Mode
for high-definition (DVI or YPbPr) programming and standard-definition
(4:3) programming. If the 4:3 Override is set to 480i and the subscriber
tunes to a 4:3 standard channel, the DCT* displays graphics overlays on
all outputs even if the DVI or YPbPr Output Mode is 1080i, 720p, or
480p.