User manual
Table Of Contents
- Front cover
- CAUTION
- IMPORTANT SAFETY INSTRUCTIONS
- Canadian Compliance
- Software License
- Copyright
- CONTENTS
- INTRODUCTION
- BASIC OPERATION
- AUDIO/VIDEO CONNECTIONS
- RF BYPASS
- OPTIMIZING YOUR DCT* OUTPUT SETTINGS
- User Options
- CONNECTING YOUR DCT*
- CONNECTING YOUR DCT* TO A HDTV – VIDEO ONLY
- CONNECTING YOUR DCT* TO A HDTV – AUDIO ONLY
- CONNECTING YOUR DCT* TO AN A/V RECEIVER – AUDIO ONLY
- CONNECTING YOUR DCT* TO A STEREO TV
- CONNECTING YOUR DCT* TO A STEREO TV AND STEREO VCR
- CONNECTING YOUR DCT* TO AN A/V RECEIVER, TV, AND VCR
- CONNECTING YOUR DCT* TO A STEREO TV, VCR, AND DVD
- RECORDING YOUR CONNECTIONS
- GRAPHICS OVERLAYING THE VIDEO
- DATA DEVICES
- TROUBLESHOOTING
- The DCT* will not power on
- The remote control does not work
- There is no audio when viewing cable channels
- There is no audio from the center and/or surround speakers of a home theater receiver connected to the DCT*
- There is no video on the TV screen
- There are no graphics, closed captions, or program guides appearing on the TV screen
- There are black bars to the right and left of the picture
- There are black bars above and below the picture
- There are black bars on all four sides of the picture
- SPECIFICATIONS
- Back Cover
30
RECORDING YOUR CONNECTIONS
Use this diagram to record connections between your home
entertainment components. Later, you can use this diagram to reconnect
your system if you move the equipment or add new equipment.
Disconnect the power from the DCT* before connecting or changing
cable connections. Do not place another component or object on top of
the DCT*.