User manual
Table Of Contents
- Front cover
- CAUTION
- IMPORTANT SAFETY INSTRUCTIONS
- Canadian Compliance
- Software License
- Copyright
- CONTENTS
- INTRODUCTION
- BASIC OPERATION
- AUDIO/VIDEO CONNECTIONS
- RF BYPASS
- OPTIMIZING YOUR DCT* OUTPUT SETTINGS
- User Options
- CONNECTING YOUR DCT*
- CONNECTING YOUR DCT* TO A HDTV – VIDEO ONLY
- CONNECTING YOUR DCT* TO A HDTV – AUDIO ONLY
- CONNECTING YOUR DCT* TO AN A/V RECEIVER – AUDIO ONLY
- CONNECTING YOUR DCT* TO A STEREO TV
- CONNECTING YOUR DCT* TO A STEREO TV AND STEREO VCR
- CONNECTING YOUR DCT* TO AN A/V RECEIVER, TV, AND VCR
- CONNECTING YOUR DCT* TO A STEREO TV, VCR, AND DVD
- RECORDING YOUR CONNECTIONS
- GRAPHICS OVERLAYING THE VIDEO
- DATA DEVICES
- TROUBLESHOOTING
- The DCT* will not power on
- The remote control does not work
- There is no audio when viewing cable channels
- There is no audio from the center and/or surround speakers of a home theater receiver connected to the DCT*
- There is no video on the TV screen
- There are no graphics, closed captions, or program guides appearing on the TV screen
- There are black bars to the right and left of the picture
- There are black bars above and below the picture
- There are black bars on all four sides of the picture
- SPECIFICATIONS
- Back Cover
DCT6200/DCT6208 User Guide
29
Connecting a Stereo TV, VCR, and DVD
This cable configuration may be used for a mono or stereo VCR,
because the VCR audio and video jacks are not used.
If your TV supports multiple sets of video and audio inputs (such as
VID1, VID2, etc.), see the diagram Connecting a Stereo TV and Stereo
VCR to connect your DCT*, VCR and TV. When you have completed
those connections, refer to the diagram illustrated here to connect your
DVD to your TV.
1 Connect an RF coaxial cable to the cable wall outlet and the CABLE
IN
connector on the DCT*.
2 Connect an RF coaxial cable to the TO TV/VCR connector on the
DCT* and the
CABLE/ANTENNA IN connector on the VCR.
3 Connect an RF coaxial cable to the TO TV connector on the VCR
and the
CABLE/ANTENNA IN connector on the stereo TV.
4 Connect a stereo audio cable to the INPUT AUDIO LEFT and RIGHT
connectors on the stereo TV and the
AUDIO OUT ANALOG R and L
connectors on the DVD.
5 Connect a video cable to the INPUT VIDEO connector on the stereo
TV and the
VIDEO OUT VIDEO connector on the DVD.
Or
Connect an S-video cable to the
INPUT S-VIDEO connector on the
stereo TV and the
VIDEO OUT S-VIDEO connector on the DVD.
The video connection method illustrated here does not support high
definition video. For more information, see “Connecting your DCT* to an
HDTV – Video Only” on page 16.