User manual
Table Of Contents
- Front cover
- CAUTION
- IMPORTANT SAFETY INSTRUCTIONS
- Canadian Compliance
- Software License
- Copyright
- CONTENTS
- INTRODUCTION
- BASIC OPERATION
- AUDIO/VIDEO CONNECTIONS
- RF BYPASS
- OPTIMIZING YOUR DCT* OUTPUT SETTINGS
- User Options
- CONNECTING YOUR DCT*
- CONNECTING YOUR DCT* TO A HDTV – VIDEO ONLY
- CONNECTING YOUR DCT* TO A HDTV – AUDIO ONLY
- CONNECTING YOUR DCT* TO AN A/V RECEIVER – AUDIO ONLY
- CONNECTING YOUR DCT* TO A STEREO TV
- CONNECTING YOUR DCT* TO A STEREO TV AND STEREO VCR
- CONNECTING YOUR DCT* TO AN A/V RECEIVER, TV, AND VCR
- CONNECTING YOUR DCT* TO A STEREO TV, VCR, AND DVD
- RECORDING YOUR CONNECTIONS
- GRAPHICS OVERLAYING THE VIDEO
- DATA DEVICES
- TROUBLESHOOTING
- The DCT* will not power on
- The remote control does not work
- There is no audio when viewing cable channels
- There is no audio from the center and/or surround speakers of a home theater receiver connected to the DCT*
- There is no video on the TV screen
- There are no graphics, closed captions, or program guides appearing on the TV screen
- There are black bars to the right and left of the picture
- There are black bars above and below the picture
- There are black bars on all four sides of the picture
- SPECIFICATIONS
- Back Cover
DCT6200/DCT6208 User Guide
23
Connecting a Stereo TV
1 Connect an RF coaxial cable to the cable wall outlet and the
CABLE IN connector on the DCT*.
2 Connect a second RF coaxial cable to the TO TV/VCR connector on
the DCT* and the
CABLE/ANTENNA IN connector on the TV.
Or
Connect the stereo audio cable to the
AUDIO R and L connectors on
the DCT* and the
AUDIO LEFT and AUDIO RIGHT connectors on the
stereo TV.
Connect a video cable to the
VIDEO OUT connector on the DCT* and
the
INPUT VIDEO on the TV or an S-video cable to the S-VIDEO
connectors on the DCT* and the TV.
This video connection method does not support High Definition video.
For more information, see “Connecting your DCT* to an HDTV – Video
Only” on page 16.