User manual
Table Of Contents
- Front cover
- CAUTION
- IMPORTANT SAFETY INSTRUCTIONS
- Canadian Compliance
- Software License
- Copyright
- CONTENTS
- INTRODUCTION
- BASIC OPERATION
- AUDIO/VIDEO CONNECTIONS
- RF BYPASS
- OPTIMIZING YOUR DCT* OUTPUT SETTINGS
- User Options
- CONNECTING YOUR DCT*
- CONNECTING YOUR DCT* TO A HDTV – VIDEO ONLY
- CONNECTING YOUR DCT* TO A HDTV – AUDIO ONLY
- CONNECTING YOUR DCT* TO AN A/V RECEIVER – AUDIO ONLY
- CONNECTING YOUR DCT* TO A STEREO TV
- CONNECTING YOUR DCT* TO A STEREO TV AND STEREO VCR
- CONNECTING YOUR DCT* TO AN A/V RECEIVER, TV, AND VCR
- CONNECTING YOUR DCT* TO A STEREO TV, VCR, AND DVD
- RECORDING YOUR CONNECTIONS
- GRAPHICS OVERLAYING THE VIDEO
- DATA DEVICES
- TROUBLESHOOTING
- The DCT* will not power on
- The remote control does not work
- There is no audio when viewing cable channels
- There is no audio from the center and/or surround speakers of a home theater receiver connected to the DCT*
- There is no video on the TV screen
- There are no graphics, closed captions, or program guides appearing on the TV screen
- There are black bars to the right and left of the picture
- There are black bars above and below the picture
- There are black bars on all four sides of the picture
- SPECIFICATIONS
- Back Cover
DCT6200/DCT6208 User Guide
21
Connecting an A/V Receiver – Audio Only
There are three options available for audio connections to your A/V
receiver:
• Optical (
OPTICAL SPDIF)
• Coaxial (
SPDIF)
• Stereo audio (
AUDIO R and L)
If your equipment supports it, the optical (
OPTICAL SPDIF) or coaxial
(
SPDIF) audio outputs may be used in place of the stereo audio outputs
(
AUDIO R and L). In most cases these outputs offer a higher level of audio
quality, including support for 5.1 surround sound.
• Optical SPDIF: Connect the optical SPDIF cable to the
OPTICAL
SPDIF
connector on the DCT* and the OPTICAL connector on the A/V
receiver.
• SPDIF: Connect the digital audio cable to the SPDIF connector on
the DCT* and the
DIGITAL INPUT COAX connector on the A/V
receiver.
• Stereo audio: Connect the stereo audio cable to the
AUDIO R and L
connectors on the DCT* and the AUDIO LEFT and AUDIO RIGHT
connectors on the A/V receiver.
For information on configuring your DCT* settings, see “Optimizing Your
DCT* Output Settings”.