User manual
Table Of Contents
- Front cover
- CAUTION
- IMPORTANT SAFETY INSTRUCTIONS
- Canadian Compliance
- Software License
- Copyright
- CONTENTS
- INTRODUCTION
- BASIC OPERATION
- AUDIO/VIDEO CONNECTIONS
- RF BYPASS
- OPTIMIZING YOUR DCT* OUTPUT SETTINGS
- User Options
- CONNECTING YOUR DCT*
- CONNECTING YOUR DCT* TO A HDTV – VIDEO ONLY
- CONNECTING YOUR DCT* TO A HDTV – AUDIO ONLY
- CONNECTING YOUR DCT* TO AN A/V RECEIVER – AUDIO ONLY
- CONNECTING YOUR DCT* TO A STEREO TV
- CONNECTING YOUR DCT* TO A STEREO TV AND STEREO VCR
- CONNECTING YOUR DCT* TO AN A/V RECEIVER, TV, AND VCR
- CONNECTING YOUR DCT* TO A STEREO TV, VCR, AND DVD
- RECORDING YOUR CONNECTIONS
- GRAPHICS OVERLAYING THE VIDEO
- DATA DEVICES
- TROUBLESHOOTING
- The DCT* will not power on
- The remote control does not work
- There is no audio when viewing cable channels
- There is no audio from the center and/or surround speakers of a home theater receiver connected to the DCT*
- There is no video on the TV screen
- There are no graphics, closed captions, or program guides appearing on the TV screen
- There are black bars to the right and left of the picture
- There are black bars above and below the picture
- There are black bars on all four sides of the picture
- SPECIFICATIONS
- Back Cover
10
OPTIMIZING YOUR DCT* OUTPUT SETTINGS
The Motorola DCT* delivers high-quality video for high definition TVs
using the YPbPr (component) and DVI-D video connectors. This section
describes how to use the on-screen display to set your DCT* to
automatically optimize both standard and high definition video based on
your HDTV and personal preferences.
You can use your on-screen menu to configure your high definition
settings for TV type, DVI and/or YPbPr video output and closed
captioning.
To access your high definition settings, ensure that your DCT* is plugged
into a power outlet and is turned off. Press the
MENU key on the front
panel. If your TV is on, the on-screen display menu appears listing the
settings you can configure.
DVI/YPbPr OUTPUT
Use your remote control or the cursor keys on the front panel to navigate
the on-screen display. Press the ▲ and ▼ keys to highlight the setting
you wish to change. Press the ► key to select an option for that setting.
To exit the setting and move to another setting, use the ▲ and ▼ keys.
To exit the menu and save your settings, press the
POWER or MENU key.
The high definition settings are described in the table on the following
pages.