User manual
Table Of Contents
- Front cover
- CAUTION
- IMPORTANT SAFETY INSTRUCTIONS
- Canadian Compliance
- Software License
- Copyright
- CONTENTS
- INTRODUCTION
- BASIC OPERATION
- AUDIO/VIDEO CONNECTIONS
- RF BYPASS
- OPTIMIZING YOUR DCT* OUTPUT SETTINGS
- User Options
- CONNECTING YOUR DCT*
- CONNECTING YOUR DCT* TO A HDTV – VIDEO ONLY
- CONNECTING YOUR DCT* TO A HDTV – AUDIO ONLY
- CONNECTING YOUR DCT* TO AN A/V RECEIVER – AUDIO ONLY
- CONNECTING YOUR DCT* TO A STEREO TV
- CONNECTING YOUR DCT* TO A STEREO TV AND STEREO VCR
- CONNECTING YOUR DCT* TO AN A/V RECEIVER, TV, AND VCR
- CONNECTING YOUR DCT* TO A STEREO TV, VCR, AND DVD
- RECORDING YOUR CONNECTIONS
- GRAPHICS OVERLAYING THE VIDEO
- DATA DEVICES
- TROUBLESHOOTING
- The DCT* will not power on
- The remote control does not work
- There is no audio when viewing cable channels
- There is no audio from the center and/or surround speakers of a home theater receiver connected to the DCT*
- There is no video on the TV screen
- There are no graphics, closed captions, or program guides appearing on the TV screen
- There are black bars to the right and left of the picture
- There are black bars above and below the picture
- There are black bars on all four sides of the picture
- SPECIFICATIONS
- Back Cover
DCT6200/DCT6208 User Guide
9
The DCT* may be equipped with an optional RF Bypass switch.
When the optional RF bypass switch is activated, it routes the cable
signal directly to a cable-ready TV, bypassing the DCT*. This
configuration enables you to view clear (unscrambled) analog
programming on the direct cable signal should the DCT* be powered off.
The RF bypass is not available on all cable systems.