Owner`s manual

6501MAHDTVMonitorOwner'sManual On-ScreenMenu
SETTINGS
¢
©
Audio Input
• Select Follow to accept audio at the audio input connector associated with the
selected video input.
• Select Video 5 to accept audio only from VIDEO 5's associated audio input, regard-
less of which video input is selected.
The Video 5 setting may be used where all audio switching is performed externally to
the HDTV monitor. It also makes it possible to use the HDTV monitor's internal audio
system for the center channel of a separate audio or home-theater audio system.
• Connect only a line-level output to any audio input. Do not connect speaker (ampli-
fied) outputs to any audio input on the HDTV. Speaker output signal levels may
damage the inputs on the HDTV monitor. Not all receivers or amplifiers have line-
level outputs accompanying speaker outputs.
To use the HDTV monitor's internal audio system for the center channel audio:
1. Set Audio input to Video 5.
2. Set the internal Speaks to On.
3. Connect the HDTV monitor's VIDEO 5: AUDIO iN to the line-level center-channel
outputs of the audio system. Note: Not all receivers or amplifiers have line-level
outputs. You may use a Y-cable to connect the audio system's center channel out-
put to both the L (left) and R (right) audio inputs on the HDTV monitor. This will use
both the channels as the single-center-channel speaker.
4. Adjust separate audio system to a comfortable listening level.
5. Adjust the HDTV monitor's volume control to a corresponding level.
• If the separate audio system has a variable (volume-tracking) line-level output, the
audio system will also control the volume of the HDTV monitor.
• If the separate audio system has a fixed line-level output, you must adjust both the
separate audio system and the HDTV monitor volume to change the overall volume.
TV Tuner
The TV Tuner menu item only appears when TUNER 1 or TUNER 2 is selected.
Pressing the i_ key, when a TV tuner is selected, displays the Input and Channel
menus.
Input
Auto Fine Tune
• Choose On to allow the HDTV monitor to adjust itself to the receive frequency of the
channel for the best picture and sound. Choose Off to enable manual fine tuning.
Fine Tune
Fine Tune is available for manually adjusting the tuner to a TV channel received
through the TUNER 1 or TUNER 2 inputs. Use Fine Tune when automatic fine tuning
is not desired.
1. Set Auto Fine Tune to Off to allow manual fine tuning.
2. Select Fine Tune.
3. Adjust the value between 0 and 100 to change the receive frequency for the best
reception. The factory setting is 50.
Veos DRAFT 2004-05-24-A_9