Owner`s manual

6501MAHDTVMonitorOwner'sManual On-ScreenMenu
Frequency
Frequency appears only for the "PC" input (analog RGB signal connected to the
VIDEO 6).
Frequency is automatically set by the HDTV monitor, but it can also be manually
adjusted.
• Adjust the frequency control for the best image. Appearance and results may vary
depending on the computer graphics card output.
• Alternately, you may force the HDTV monitor to automatically reset the frequency by
pressing the DASH key on the remote control. See "Dash" on page 35 for additional
information.
Figure 19. Correct Frequency Setting
To see the change, locate an easy to observe graphic item along the edges of the
screen image. Look for undesired cropping.
Cropped
Figure 20. Frequency Too Low
Cropped
Figure 21. Frequency Too High
This adjustment accommodates differences in computer graphic cards.
Phase
Phase appears only for the "PC" input (analog RGB signal connected to VIDEO 6).
Phase is automatically set by the HDTV, but it can also be manually adjusted.
• Adjust the phase control for the best image. Appearance and results may vary
depending on the computer graphics card output.
• Alternately, you may force the HDTV monitor to automatically reset the phase by
pressing the DASH key on the remote control. See "Dash" on page 35 for additional
information.
This adjustment accommodates differences in computer graphic cards.
Veos DRAFT 2004-05-24-A_3