OWNER'S MANUAL 4 0 " L AW N A E R ATO R MODEL: SA-400BH • Assembly • Installation • Operation • Repair Parts Original Instructions For the latest product updates & setup tips: Visit us on the web! www.brinly.com Important: This manual contains information for the safety of persons and property.
INTRODUCTION AND SAFETY ================================================================================================ CONGRATULATIONS on the purchase of your new Brinly-Hardy Aerator! Your Aerator has been designed, engineered and manufactured to give you the best possible dependability and performance. Should you experience any problem you cannot easily remedy, please do not hesitate to contact our knowledgeable customer service department toll-free at 1-877-728-8224.
PARTS REFERENCE ================================================================================================ INSTALLATION QUESTIONS? MISSING PARTS? Tools Required: (1) Flat Head Screwdriver (1) 1/2” Wrench (1) Set of Pliers or Hammer (1) Pair of Gloves. REPLACEMENT PARTS? STOP DON’T GO BACK TO THE STORE! Please call our Customer Service Department Toll-Free at 877.728.8224 or www.customerservice @brinly.
ASSEMBLY ================================================================================================ Figure 1 1. 2. 12 Install Drawbar (3) to the Tray (5) using two 5/16" X 1" Round Head Screws (11), two 5/16" Lock Washers (13), and two 5/16" Hex Nuts (12) as shown in Figure 1. 12 3 Assemble the Clevis Drawbar (20) to the Drawbar (3) using two 5/16" X 1" Round Head Screws (11), two 5/16" Lock Washers (13), and two 5/16" Hex Nuts (12). See Figure 1.
ASSEMBLY ================================================================================================ CAUTION: Gloves are required when handling aerator tines. Tines have extremely sharp points. Use caution when handling. 6. Figure 4 15 17 Position the 10 Tines (8) and 20 Bearings (9) onto the Tine Shaft as follows: * Bearing (9), small end first * Tine (8) * Bearing (9), large end first See Figure 4.
OPERATION ================================================================================================ Figure 6 DEPTH / PENETRATION OF TINES CAUTION: Avoid injury! Openings in Tray allow access to Tines for cleaning and service. Excercise caution when working around Tray openings and avoid placing body parts into the openings. Bagged weight material can fall through Tray Openings and be torn open or damaged by the Tines.
MAINTENANCE-STORAGE ================================================================================================ MAINTENANCE The key to years of trouble-free service is to keep your Aerator clean and dry. After the first 30 minutes of use, check all fasteners for tightness. Thereafter, periodically check all fasteners for tightness. Tines are manufactured with galvanized steel to resist wear of abrasive soil. Striking objects can cause Tines to curl or break.
MANUFACTURER’S LIMITED WARRANTY FOR Pull Behind Accessories The limited warranty set forth below is given by Brinly-Hardy Company with respect to new merchandise purchased and used in the United States, its possessions and territories. Brinly-Hardy Company warrants the products listed below against defects in material and workmanship, and will at its option, repair or replace, free of charge, any part found to be defective in materials or workmanship.
