Troubleshooting guide
Electrical Requirements
)g
ELECTRICAL
SHOCK HAZARD
Plug into a
grounded
3
prong
outlet.
Do not remove
ground
plug.
Do not use an adaoter.
Do not
use an extension cord.
Failure
to
follow
these
instructions
can
result in death or electrical
shock.
a
a
A 12O-volt, 60-H2.,
AC-only, 15-
or 2O-ampere,
f
used electrical
supply is required. Time-delay f
use
or circuit
breaker is recommended. lt is recom-
mended that a separate circuit serving only this
appliance be
provided.
This washer is
equipped
with
a
power
supply cord
having
a
3
prong
ground
plug.
To minimize
possible
shock hazard, the cord must
be
plugged
into a mating, 3
prong,
ground-type
outlet,
grounded
in accordance with local
codes
and ordinances.
lf
a
mating
outlet
is not
available,
it is the
personal
responsibility
and obligation of
the
customer to have the
properly
grounded
out-
let installed by a
qualified
electrician.
lf codes
permit
and a separate
ground
wrre is
used,
it is
recommended
that a
qualified
electrician de-
termine that the
ground path
is
adequate.
Do not
ground
to a
gas
pipe.
Check with a
qualilied
electrician
if
you
are not
sure the washer
is
properly grounded.
Do not have a
fuse
in the neutral or oround circuit.
f .
:l
Frnq0 Sq"&rrr$lng
pAlF
l
S
prong
trftInotnp"
typa
trxt
natrq@ctu
,3.
Gn"trn*rp
g*nrgr
4.
fiil*er
safig{r c*rs
GROUNDING
INSTRUCTIONS
For a
grounded,
cord-connected
washer:
This washer
must
be
grounded.
In
the event
of
a
malfunction or breakdown,
grounding
will reduce
the
risk
of electrical
shock by
providing
a
path
of
least resistance
for electric current. This washer
is
equipped
with
a
cord having
an equipment-
grounding
conductor and a
grounding
plug.
The
plug
must be
plugged
into
an appropriate outlet
that
is
properly
installed
and
grounded
in accor-
dance
with
all
local codes and
ordinances.
WARNING:
lmproper
conneclion of the equip-
ment-grounding
conductor can
result in
a
risk
of
electric
shock. Check
with
a
qualified
electrician
or serviceman
if
you
are
in
doubt
as
to whether
the
appliance
is
properly grounded.
Do
not modify the
plug provided
with the appli-
ance
-
if it will
not fit
the
outlet,
have
a
proper
outlet
in-
stalled by a
qualified
electrician.
For a
permanently
connected washer:
This washer must be connected to a
grounded
metal,
permanenl
wiring system,
or an equipment
grounding
conductor
must
be
run
with the circuit
conductors
and connected to
the equipment-
grounding
lerminalor
lead
on the appliance.
INSTALLATION
INSTRUCTIONS
Remove
Transport
System
IMPORTANT:
Position
the washer
so
that the rear
of
the unit
is within approximately 3 feet
(90
cm)
of the
final location.
Excessive
Weight Hazard
Use
two or
more
people
to move and in-
stall
washer.
Failure to do
so can
result
in back or other
injury.
1-3