Troubleshooting guide

REMOVING THE HEATING ELEMENT
AND TEMPERATURE
SENSOR
Disconnect
the
wiring harness
connectors
from
the heating
element
terminals
and
loosen
but do
not remove the 10-millimeter nut between
the
heating
element
terminals.
(Fig.
3-29)Then slide
the heating
element
from the tub. Slide the
tem-
perature
sensor
from
the
heating
element bracket.
Temperature
Sensor
lOmm Nut
REMOVING THE
TUB
AND DRUM ASSEMBLY
There
are three concrete
weights
attached to the
tub
assembly.
All three must be removed for
safe
removal
of the
tub assembly.
Access to the
weight
on the top
front
of the tub
requires removing the six screws
securing the
top front frame
member from
the
washer
and re-
moving the frame member.
(Fig.
3-30A)
Fig.3-304
Access
to
the weight on the top back of the tub
requires removing the two screws securing the
top
frame
member to the
washer
and
removing
the frame member.
(Fig.
3-308)
Top
Frame
(Back)
secured to the tub by three
13-
(Fig.
3-31)Remove the
three
weight from the
tub.
Bolts
Bolts
Fig.3-31
nuts
from
the tub
for safekeep-
Each
weight is
millimeter bolts.
bolts and
lift the
Remove the
flat
ing.
(Fig.
3-32)
Top Frame
(Front)
Fig.3-32
Fig.3-308
3-8