Troubleshooting guide

To remove
the
pump
assembly, begin by opening
the door covering the wiring harness connector
and
disconnect
the
wiring harness from
the
pump
motor terminals. Remove
the screw securing the
pump
assembly to the washer frame.
(Fig.
3-24)
Once the
pump
is removed the drain hose
and
tube outlet hose can be removed.
ACCESSING THE
MOTOR
CONTROL UNIT
Access to the Motor Control Unit may require
removing the left
front
shock absorber.
Using a
flat
bladed screwdriver,
lift
up on the
plastic
tab under the
front right
corner of the
motor
controller
box.
(Fig.
3-26
-
INSET)
Fig.3-24
REMOVING THE
SHOCK
ABSORBERS
The
tub
is held in
position
by
four
shock
absorb-
ers, two
in front
(Fig.
3-25)and two at the back.
Each
shock absorber can be disconnected
from
the tub by turning the top of the shock mount
counter clockwise. 90".
The
shock can be
re-
moved from
the
washer
by
turning the
bottom
shock mount counterclockwise. 90'.
Fig.3-25
Fig.3-26
Slide the box
forward
to
release the two tabs at
the back of the box
from
the bottom
panel
of the
washer.
(Fig.3-27)
Fig.3-27
Open the door
on the control box to access to
the test
points
of
the Motor Control Unit.
(Fig.
3-
28)
3-7
Fig.3-28