Troubleshooting guide

REMOVING THE
MAIN
CONTROL
BOX
AND PRESSURE
SWITCH
The main
control box
is
a single assembly and
does not
contain any serviceable
parts.
lt
can be
removed
by
lifting
the top
plastic
tabs securing
it
to the back
cabinet
frame
and
sliding it towards
the front
of the
washer.
(Fig.
3-19)
Tabs
ro remove,n"
p,".L11.1,1,'n.n,
rirst remove
the
wiring harness retainer from
the
side of the cabi-
net.
(Fig.
3-20)
rhendisconnectr^:t;,::rt^arnessconnecrors
and the
pressure
hose and turn the
pressure
switch counterclockwise to release
it from
the
cabinet.
(Fig.
3-21)
Pressure Switch
REMOVING
THE DRIVE MOTOR
The
drive
motor can be
removed once the back
panel
has
been
removed.
Twelve screws secure
the back
panel
to the
washer. Remove the
12
screws
and remove the
back
panel.
Remove the Drive
Belt.
Disconnect
the wiring harness connectors and
ground
wires from the drive
motor
terminals.
Push
the
wiring harness tie
from the motor
mounting
bracket.
Remove the
mounting bolt securing the
motor
to
the tub.
(Fig.3-22)
Fig.3-22
REMOVING THE
PUMP ASSEMBLY
The
pump
assembly can
be accessed once the
toe
panel
has
been
removed.
To
clean
out the
large item
filter,
turn the
large
knob
counterclockwise
and
pull
it
out.
(Fig.
3-23)
Fig.3-23
Fig.3-21
3-6