Troubleshooting guide

Pump Motor
A
separate
pump/pump
motor is
used to
drain the wash
lub.
(Fig.
2-14) The
pump
motor is 120 VAC
and is at-
tached directly to the
pump.
The
pump
has
a clean-out
filter located
at the
front
that allows
for
the
removal
of
large
objects that
may have
passed
from the drum.
(Fig.2-15)
Eco Valve
The washer has
a
specially designed
valve
that closes
during the
wash
portion
of the cycle so that 100% of the
water
and detergent
mixture is used
on
the wash load.
The Eco Valve
insures
that
no water
or detergent
is
wasred.
(Fig.
2-1a &
2-16)
Suspension System
The wash
tub
is held in its horizontal
position
with four
pneumatic
shock absorbers attached to
the
bottom
four
corners of
the tub assembly.
In
addition, the
wash
tub
is
suspended
from the top frame of the washer
with
two springs attached to the sides of the
unit.
Stability
for
this
suspension system
is
provided
by
three
concrete
counter
weights.
Two are
located
at the
front of the wash tub. One
is
positioned
at
the back of
the
tub. These
counter
weights eliminate the need for
the traditional balance ring.
(Fig.
2-1 7)
Counter
Weights
(3)
Fig.2-16
Shock
Absorbers
(4)
Fig.2-17
Drain
Pump
Fig.2-14
Fig.2-15
2-8