Troubleshooting guide
2.
Select a
Wash Cycle.
3. Select AUTO SOAK.
NOTE: For
cycles
with hot wash temperatures,
the soak temperature will be set to
warm;
otherwise, the soak temperature
will
be the
same as the
wash
temperature.
4.
Select and
hold START
(approximately
1
second). After soaking,
the
washer
drains
and the wash cycle starts.
Without a Wash Cycle: Provides a soak
time
with warm
or cold
water followed by drain.
1.
Add detergent only to
the Prewash compart-
ment
of the
Dispenser Drawer.
2. Select DRAIN/SPIN or
RINSE/SPIN first.
then AUTO SOAK.
3. Choose the desired
soak temperature.
4.
Select and
hold START
(approximately
1
second).
2nd Rinse
A
second
rinse can be used to ensure the
removal
of detergent or bleach
residue from
garments.
This
option
provides
an additional
rinse with the same water temperature as the
first rinse.
Extended
Spin
Use this option to add
an additional spin to any
cycle to improve the
"fluff"
of
your
laundry, to
reduce
drying time,
and to save energy.
Modifiers
Preset
cycle settings
of Water
Temperature,
Wash/Rinse, and Spin Speed
can be changed.
You
can change a
modifier after starting a cycle
anytime before the selected
modifier begins.
Touch
Pad/LED
Assembly
.
To change the
water temperature, select the
WATER
TEMP button
untilthe desired
setting
glows.
.
To change the
spin speed, select
the SPIN
SPEED
button until the
desired setting
glows.
.
To change the
loudness of the
End of Cycle
Signal,
select
END of CYCLE SIGNAL.
Wash/Rinse
Temp
Select
a
water
temperature
based on the type
of
load
you
are
washing. Use the
warmest
water safe
for fabrics.
Follow
garment
label
instructions.
Warm
rinses leave the
loads dryer than
cold
rinses. Warm
rinses increase
wrinkling. In cold
climates,
a
warm rinse
makes the load
more comfortable
to
handle. Cold rinses save
energy.
Auto
Temp Control
ATC
(Auto
Temp
Control)
electronically
senses
and
maintains a
uniform
water temperature.
ATC
regulates incoming
hot and cold
water. The
ATC is automatically
turned ON
when a cycle
is
selected.
.
ATC ensures
consistent
cleaning.
.
ATC works
for the
wash
temperature
with
Extra
HoVCold,
HoVCold,
WarmMarm,
Warm/Cold, and
Cold/Cold
settings.
.
The Cold
rinse temperatures
depend on the
cold
water
at
the tap.
.
For the
Tap
Cold/Cold
setting,
both
wash
and rinse temperatures
depend on the
cold
water at
the tap.
.
The Warm
rinse setting
regulates the
water
temperature
at approximately
104"F
(40'C).
Touchpad/LED
Assembly
Ribbon Gable
Fig.2-10
The Touch Pad/LED
Assembly,
(Fig.
2-10), is a single assembly
and
is connected
to the Central
Control Unit by a ribbon cable.
This assembly contains
all of the buttons,
LEDs and
ribbon cable
and
printed
circuit boards
for
the user to
operate the
washer.
The interfaces
the consumer
inputs
to the Central Control
Unit.
2-6