Troubleshooting guide
Pressure
Switch
The
pressure
switch is located in
the top right rear corner of
the
washer
(Fig
2-7) This
switch
senses water level
in
the
wash tub. The control
signal from the
pressure
switch
is
sent
to
the Central Control
Unit and is used
to determine
the
amount of
water introduced
into
the
wash
tub durino the
wash
cycle.
The
pressure
switch also senses
the suds level in the
wash
tub. lf excessive sudsing
occurs, the washer
starts an
auto-
matic
suds
routine. The
display will
show the word SUDS.
The
automatic suds
routine
adds additional rinse
and drain opera-
tions untilthe suds
level is
reduced.
Customer
Interface
and
Cycle Selection
Status
Indicators
Fig.2-B
Pressure
Switch
Display
Delay
Start
Soil Level
(Change
Cycle
Time)
Pause
Cancel
Delay
Start
-
To
start the washer
at
a later time,
press
the
DELAY button until the
desired
delay
start time
(in
hours)
shows in the Display, then
select
START.
The
countdown to the start time
will
show
in the display.
Soil
Level- Pressing this button willchange the
length of the
wash
cycle.
Heavy will
add time to a
normal
wash cycle, light will shorten
a
normal
wash
cycle.
Pause/Cancel
-
Pressing
this
button will
allow
changing
any option or changing a
wash
cycle
after
the
wash cycle has begun. Press the
PAUSE/CANCEL
button,
select the desired Op-
tion,
press
and
hold the START button for one
(1)
second.
To cancel a cycle and select a new one,
press
the
PAUSE/CANCEL
button, select the
new
cycle,
select the desired options,
press
and
hold
the START
button for one
(1)
second.
Extra
Gycle
Selection
Wash Cycle
Selector
Status Indicators
-
These lights
show which
portion
of
the
cycle the washer
is operating. They
also indicate when additional items
can be added
to the wash cycle and when
the controls are
locked.
Extra Cycle Selection
-
The
Rinse/Spin selec-
tion operates a
rinse
and
spin cycle only.
This
cycle combines
fast
speed tumbling
and extra
high
speed
spin. The spin speed
can be reduced by
selecting a speed from
the SPIN SPEED modi-
fier.
Wash Cycle Selector
-
Choose a Wash Cycle
by selecting the button next to
the desired cycle.
Each cycle
is
designed
for
different
types of
fab-
ric and soil levels.
(See
Table
2-1, Page 2-4)
Display
-
The display
provides
such
information
as time
remaining for
selected wash cycle
and
error codes.
Fig.2-7
2-3