Owner`s manual

USING THE LIQUID FABRIC
SOFTENER DISPENSER
After loading the washer, measure and
add the recommended amount of fabric
softener into the dispenser. Follow
manufacturer's directions.
NOTE: Pouring too much fabric softener
into the dispenser will cause the fabric
softener to dispense instantly into the
load due to siphoning action. This
instant "dump" could damage fabrics
and will make it appear that your dis-
penser is not working correctly.
• Add warm water to fill the dispenser
until it reaches the crossed opening at
the bottom of the funnel-shaped
portion of the dispenser.
• Fabric softener is dispensed into the
first deep rinse water automatically.
NOTE: Fabric softeners are not com-
patible with detergents. This dispenser
should never be used in the PREWASH
Cycle since it would dispense fabric
softener into a wash load that has not
been rinsed, Undiluted fabric softener
spilled on fabric may result in spots that
look like oil stains.
If you ever use your dispenser this way
by mistake, rewash the load with extra
detergent to remove these deposits.
To remove the Fabric Softener
Dispenser for cleaning:
1. Pull the blue lock ring up, then
remove dispenser from agitator by
pulling up,
2. Flush the dispenser with warm water.
To replace the Fabric Softener
Dispenser:
1. Be sure the blue lock ring is pulled
up. Starting at an angle (see
illustration), push the bottom of the
dispenser down on the agitator top.
2. When the dispenser is seated on the
agitator, push the blue lock ring down
until it snaps in place. It must fit
tightly.
Liquidfabricsoftener
dispenser
/ r sJ
_. /_ BlueIockring
24