Owner`s manual

Problem Possible Cause Solution

Won't Water inlet valve Clean screens.

Fill/Won't screens are plugged.

Rinse/Won't

Agitate/ Water is turned off. Turn on water.

Wrong Hot and cold hoses are Reverse hoses (see "Installation

Temperature/ reversed. Instructions," Sections D & E),

Shortened

Cycle Inlet hose is kinked. Straighten hoses.

Power cord not plugged in. Plug in power cord.

Oversudsing detected. Do not start with excess water in the

machine. Drain/Spin load; restart cycle.

Do not add detergent.

Machine Power cord not plugged in. Plug in power cord.

Stops

No power at plug. Check electrical source or call

electrician.

Fuse blown or circuit Replace fuse or reset circuit breaker.

breaker open. If problem continues, call electrician.

Using an extension cord. Do not use extension cords.

STOP/CANCEL pad was Set a new wash cycle and press

pressed. START pad.

DELAY START pad was pressed. Press START pad to restart washer.

If console light is off, set a new wash

cycle, then press START pad.

Washer at pause in Allow cycle to continue

PERMANENT PRESS Cycle (see "Operating YourWasher").

(approximately two minutes).

Machine is overloaded. Wash smaller loads.

Agitator Not The top of the agitator moves This is normal.

Working only in one direction.

The top of the agitator is loose. This is normal.

Water Level The top of the agitator is much This is normal.

Too Low/Not higher than the highest water

Completely level, This creates a perception

Filling of the washer not being full.

Tub is Tub pulled forward when Ensure tub is centered before

Crooked unloading, starting washer.

Tub moves. This is normal.

Unit not level. Ensure front feet are installed and

nuts are tightened. Level washer.

Reset rear legs (see "Installation

Instructions," Section G),