Owner`s manual

Problem Possible Cause Solution
Won't Drain hose is kinked or Straighten or unplug hose (see
Drain/Won't clogged. "Installation Instructions," Section C).
Spin/
Wet Loads Correct operation of After a wash or rinse, the washer will
neutral drain, drain without spinning.After draining,
the spinning begins.
Lid is open. Close the lid,
Drain hose is more than Lower drain hose (see "Installation
96 in (2.4 m) above floor. Instructions," Section C).
Toomuch detergent - Use less detergent.
excessive sudsing.
Wrong cycle for load Choose a cycle with a higher spin
being washed, speed (see "Operating Your Washer").
Low voltage or using an Check electrical source or call
extension cord. electrician. Do not use extension
cords.
Cold rinses. Cold rinses leave loads wetter than
warm rinses. This is normal.
Continues Drain hose is less than Raise the drain hose (see "Installation
to Fill/ 39 in (99 cm) above floor." Instructions," Section C).
Continues
to Drain/ Drain hose fits tightly into Adjust drain hose for loose fit (see
Cycle Stuck standpipe. "Installation Instructions," Section C).
Drain hose taped into Do not seal off drain hose with tape.
standpipe. The drain hose needs an air gap,
Washer Makes Load is unbalanced. Redistribute load.
Noise
Washer is not level. Level washer. Reset rear legs (see
Rear leveling legs not set, "Installation Instructions," Section G).
Nuts on front feet not tight. Tighten nuts (see "Installation
Instructions," Section G).
Yellow shipping strap with Remove strap with cotter pins
cotter pins not completely (see "Installation Instructions,"
removed. Section B).
Floor not strong enough Relocate washer (see "Installation
to support washer. Instructions," Section A).
Gears engaging after drain This is normal.
and before spin.
Upper part of agitator clicks This is normal.
during wash.
43