Use & care guide

DustBin
Release
Wand
Release
BrushRoll
On/Off
Power switch/Power
Nozzle brushroll switch
The Power on/off button is located on
the top of vacuum body.
Turn on vacuum by power button after
plugging cord into electrical outlet.
The Power nozzle brush on/off button
turns the rotating brushroll on and off.
Turn brushroll switch on to clean carpet
and rugs.
Turn brushroll switch off to clean hard
surface floors.
The brushroll will automatically turn
offwhen the handle is in the upright
position.
Circuit breaker
(Reset switch)
The circuit breaker turns off the brush-
roll if its motion becomes obstructed.
The brushroll will stop, but the suction
motor will continue to run.
To reset the breaker, turn cleaner off
and unplug it. Clear the obstruction from
brushroll area.
Press reset switch to the on position,
turn cleaner on and continue
cleaning.
HEIGHT ADJUST KNOB
1. Place handle in upright position
2. Turn height adjustment knob to
desired setting
Lowest setting - For bare floors
4-step carpet setting - For various
carpet heights
Low carpet setting
- For short pile carpets
intermediate carpet settings
- For medium pile carpets
High carpet setting
- For plush pile carpets
Note : For optimal cleaning
performance, adjust to the lowest
practical setting. If your cleaner is
difficult to push, adjust to the next
higher setting.