Specifications

• • • • • • • • •
AC POWER SO CKET
PROGRAM CARD SLOT
EX TE RNAL
SP EAKER JA CK
G RO UN D TERM I NA L
DC
POWE R SOC KET
Insert your program card into this slot. For programming desirable frequencies on
the program card refer to "Program Card Programming" in the other booklet
provided and titled as "CODE BOOK",
CHANNEL SKIP BUTTONS
These skip buttons are provided to turn each individual channel on or off. When a
button is set to the off position (button in), the corresponding channel is sk ipped
(by-passed) and
will not flash or receive signals in either the manual or automatic
scanning mode.
AUTO/MANUAL SWITCH
Auto: Set the Aoto/Man u al switch to the AUTO position for automatic scanning.
In addition, the receiver must be squelched ON. To squelch ON the unit, turn the
Squelch control until all the "noise" from the speaker is eliminated and scanning
action
is obtained.
Manual: Activate the channel you want to monitor and then set the Auto /Manual
switch
to the MANUAL position for manual selection of the channel to be
monitored .
ANTENNA JACK
The antenna jack may be used to connect the VHF-UHF telescop ing antenna
provided,
or for increased I istening range, outdoor-type antennas are available from
your Sears store.
Your choice of antenna type should be determined by location and service
conditions under which the equipment will be used. Various types of antennas
are
available (optional). See Sears' display.
Note: When
installing the antenna, be sure to recheck all fittings and connectors
for proper assebmly to avoid shorts or open circuits .
-2-