HOME CLEANING SYSTEM MODEL NO.175,8690290 CAUTION: Read Instructions and Rules for Safe Operation Carefully For Household Use Only Save this Manual for Future Reference 555-3929 MJ_HLIAL- LI&C '.BUCK AND CO., Dept.
Read all instructions When using any electrical appliance, WARNING I, 2, 3. before basic precautions -To reduce using should this cleaner. always This vacuum cleanerisfor use on a nominal120 .volt circuit, and has a grounded plug (seefigure A), A temporary adapter (seefigure B) may beu_ed to connectthis plug toa 2-polereceptacle(seefigure B)irapraperlygrounded ouflet isnotavailable. The temporary adapter should be used only until a properly grounded outlet (see 9.
TABLEOF CONTENTS Additional Uses / Optional Accessories ................... page 8-9 Trouble Shooting Chart ................................................ page 10 Exploded Views and Parts Lists ............................ page 11-14 Notes ................................................................................ page 15 Ordering Parts ................................................................ page 16 Safety Instructions ...........................................................
ASSEMBLYOF RECOVERY TANK AND SOLUTION TANK POWER HEAD O0wER RD See Figure 2 1, Place Recovery Tal& into Solution Tank (align the word "VACUUM" on Recovery Tank with "VACUUM" on Solution Tank) and secure with Metal Latch. 2, Insert the plug on the Short Cord from the Solution Tank into the Recovery Tank Power Head. ASSEMBW OF HOSE, WANDS, NOZZLE AND SOLUTION TUBING See Figure 1 1. Assemble the two Straight Wands. 2. Assemble the upper Straight Wand to the Angled Wand of the Hose.
CARPET PREPARATION For best results prepare carpet for cleaning as follows: 1. Vacuum carpet to remove loose dirt before using Cleaner, 2. To remove stains and ground in dirt present in heavy traffic areas of the carpet, spray or rub Sears Heavy Traffic FreTrealanent (82833) into carpet before using Cleaner. Follow directions on the bottle. FILLING CLEANER WITH WATER AND CLEANING SOLUTION FILLER OPENING See Figure 4 1. Open lid of the Filler Opening. 2.
TESTFOR SOLUTION SPRAY See Figure 6 1. Hold Floor Nozzle 2. 3. above floor level. Pull Solution Release Trigger on Angled Wand. Observe Floor Nozzle to make sure cleaning solution is being sprayed evenly. (see DETAIL "A" ) NOTE: If solution is not being sprayed Trouble Shooting Chart. evenly, refer to CLEANING THE CARPET See Figures 7 & 8 Solution Dispensing Stroke: 1. Start at a corner (recommended). 2. Place Floor Nozzle so Suction Inlets are flush with carpet. 3.
WHEN TO EMPTY RECOVERY TANK See Figure 9 RECOVERY TANK During normal operation, your cleaner may stop recovering solution from your carpet, When this occurs there are three check points to alert you: 1, An increase in motor noise, 2. 3. No solution visibly being recovered by the floor nozzle. No air coming from the exhaust port of your cleaner. When this occurs: 1. The Recovery Tank is full and the Float Valve in the Recovery Tank has been activated. The Recovery Tank should be emptied. or -- 2.
TO EMPTYTHESOLUTION TANK METHOD ! See Figure 11 When cleaning is completed, both the Recovery Ta nk and the Solution Tank should be emptied prior to storage. Empty the Recovery Tank as described earlier. There are three methods of emptying the Solution Tank. Method 1: 1, Disconnect Short Cord from Recovery Tank. 2. Remove Recovery Tank from Solution 'rank solution out of the Filler Opening. Method 2: 1. Place Floor Nozzle in bath tub or container, and pour 2.
PAPER DUST BAG (20-5086) See Figure 15 This cleaner uses a disposable paper dust bag to trap and collectdirt when used for dry pick up. It is very important that the disposable paper dust bag remain clean to allow air to pass through it while trapping dirt, If the dust bag is over filled or its pores become clogged from fine powders, no air can pass through, This greatly reduces the efficiency of your cleaner and could cause the dust bag to burst.
USEAS A BLOWER See Figure 16 1. Insert Hose into the Exhaust Port of the Power Head. 2, Turn Power Switch "ON" and direct hose to area to be blown. KENMORE SPRAYMATE ATTACHMENT MODEL NO. 2°83252 See Figure 17 Cleanmore Spraymate is an optional attachment for carpet cleaning.
PROBLEM !, Neither vacuum runs. POSSIBLE SOLUTIONS * motor nor pump 2, Vacuum motor runs, but spray at the nozzle. 3, Spray from the floor come out evenly, motor there Is no nozzle does not 1, Be sure power switch is in "ON" position, 2. Be sure power cord ts plugged In securely, 3.
SEARS HOME CLEANING SYSTEM -- MODEL 175.
SEARSHOME CLEANING SYSTEM-- MODEL 175.
NOTES
Kenmore HOME CLEANING SYSTEM SERVICE Now that you have purchased your Kenmore Home Cleaning System, should a need ever exist for repair parts or service, simply contact any Sears Service Center. Be sure to provide all pertinent facts when you call or visit. MODEL NO. 175.
