User manual

Yukon HX Motherboard User Manual

SCSI Driver Installation

Win 95 Driver Installation

There are two scenarios regarding Yukon HX SCSI driver installation for Windows 95:

(a) installing under Windows 95 new version; and (b) installing under Windows 95 old

version. If the computer does not automatically install the SCSI driver for you, your

Windows 95 is an older version. Please refer to scenario (b) for SCSI driver installation.

Windows 95 New Version:

1. Power up the computer and start Windows 95.

2. Windows 95 will automatically detect any new hardware. A “New Hardware

Found

” screen appears once it detects the Adaptec AIC-7860 PCI-to-UltraSCSI

Controller Chip. Your system will locate and install the built-in Adaptec 7860 SCSI

driver automatically.

3. To finish setting up your new hardware, you must restart your computer.

If your computer does not automatically install the SCSI driver for you, your Windows

95 is most likely an older version. You need to install the SCSI driver by referring to the

following section.

Windows 95 Old Version:

1. Boot up the computer and install Windows 95.

2. Go to Control Panel \ System \ Device Manager \ Other Devices