Owner's manual

ManualsBrandsSeametrics ManualsEquipmentAG2000-Series

FEATURES

Welded steel epoxy-coated

ow tube

Flanges, ANSI 150 lb. drilling

Cross-drilled screws (2) for tamper-evidence

Power/Output cable port access,

Tamper-sealed

Rate and total indicator

316SS electrodes

Equalization lug

Tamper-evident security seal

Powder-coated diecast-aluminum electronics housing

Dual durometer rubber liner

AG2000

IRRIGATION MAGMETER

INSTRUCTIONS

AG2000 IRRIGATION MAGMETER INSTRUCTIONS

9 001:2008

CERTIFIED COMPANY

ISO

Internal data logger (Optional)

Summary of content (4 pages)

PAGE 1
AG2000 FEATURES Rate and total indicator Powder-coated diecast-aluminum electronics housing Cross-drilled screws (2) for tamper-evidence Tamper-evident security seal Internal data logger (Optional) Power/Output cable port access, Tamper-sealed Equalization lug Welded steel epoxy-coated flow tube 316SS electrodes Dual durometer rubber liner Flanges, ANSI 150 lb.
PAGE 2
INSTALLATION Tamper-Evident Seal. The battery-powered AG2000 has a seal wire to protect against unauthorized access. The seal can be broken to change units of measure, replace the battery pack, or to field-install a power/output cable (see page 4). CAUTION: If water usage regulation is in effect, only a person authorized by your regulatory agency should break the seal wire, and replace it when finished. Straight Pipe Recommendations. See the diagrams below for manufacturers’ recommendations.
PAGE 3
POWER SUPPLY and OUTPUTS EQUALIZATION and GROUNDING Metal Pipe Installations. To equalize the electric potential of the fluid, the meter, and the surrounding pipe, secure the flange plates, factory-installed on equalization lug, to both pipe flanges at one of the bolt holes. Be sure the lockwasher provided fits between the pipe flange and the flange plate. Meter Flange Pipe Flange Lockwasher Flange Plate Plastic Pipe Installations.
PAGE 4
OPTIONAL INPUTS, OUTPUTS and TROUBLESHOOTING Optional Input and Outputs. An optional cable, factoryinstalled or field-installed by an authorized individual, provides power input, pulse output* for remote reading (4-20 mA conversion, telemetry and data logging functions). See diagram below. Detailed wiring diagrams provided with cable. IMPORTANT: When field installing the input/output cable, be sure to snugly tighten the cable strain relief to prevent water ingress.