User manual

Seamax Inflatable Boat – English User Manual
- 19 -
Using an Outboard Motor
Choose an outboard for the boat that is in accordance with the horsepower range and limit. Refer to the
Specification table in this manual or the manufacturer's plate on the boat for the maximum outboard capacity.
Install the outboard along the centerline of the boat transom. Fasten the outboard to the transom following
the recommended installation instructions provided with the outboard or its manufacturer.
Check outboard for tightness on transom before each use. When you install an outboard motor, make sure
you place it on the motor bracket at the transom and tighten the butterfly bolts to the transom Check after
15 minutes of boating to ensure the butterfly bolts are still tight to the transom.
Self Draining
SEAMAX inflatable boats come with two styles of self draining system. To test the valve, while in a forward
motion remove the plug from the drain and the water will automatically run out. The inner diaphragm will
prevent water from returning. After the water has been drained, replace the plug. Make sure you have pulled
out the black plug when you are sailing or towing the boat. It is important to keep the self-draining system
clear.