User manual

Seamax Inflatable Boat – English User Manual
- 11 -
Air floor Boat Assemble
Unfold the floor on a clean flat surface that is free of any sharp objects that could damage the air mat
Lay the floor flat and ensure that all valves are snug and the air valve is in the closed position. Install plywood
slat in holder(under the 2 strap) this is to provide the support to push down the inflatable keel to provide a
deep V keel under the boat .check over to make sure there are defects.
Inflate floor with provided foot pump, once inflated inspect and become familiar with the design and how it
will fit in the boat. Once you are familiar with the floor deflate (push the valve stem in and twist) the air mat.
Take the air series boat and lay out on a clean flat surface, pump the air champers of the boat to about 50%.
This will pull the fabric away from the inner sides of the chambers of the boat to make installing the air mat
much easier. Install the air mat with plywood support down into the boat.
Make sure that the hole in the front lines up with the valve on the inflatable keel, once installed in the bottom
of the boat finish inflating the sides , once that is done inflate the air mat floor. You can double check the
positioning as you go along by pushing down on the edges of the floor as you inflate it .When you have the
floor inflated and in the proper position, inflate the keel. The plywood support will force the keel down to
provide a deep V on the bottom of the boat; this will provide added stability in the water
Tip: You can inflate and deflate the boat and air mat floor together and roll up as one piece
Tip: Wash and clean the sand and dirt from the air mat floor after each use to avoid sand or dirt from
getting inside and damaging the air valve
Note: Inflate the keel chamber only after you have inflated all other chambers of the boat and floor.
Note: The first time you install floor and inflate the boat it may take up to 45 minutes to complete.
Pressure Standard:
• Tube air chambers – Max 3.6PSI / 25kPa
• Inflatable Keel chamber – Max 5.0 PSI / 35kPa
• Airmat floor chamber – Max 10 PSI / 70 kPa
NOTE: Detail Photo Instruction for Setup is available on www.seamaxboat.com.