User's Manual
FCC CAUTION
To assure continued compliance and possible undesirable interference, ferrite cores may be used
when connecting this TV to video equipment; maintain at least 400mm (15.75 inches) spacing to
other peripheral devices.
29. Do NOT use any other power cords or connection cables than what is provided with the product
or from the manufacturer directly. Use of untested, unauthorized, or substituted power cords or
connection cables may be a cause for malfunction, re, electric shock, or severe damages to the
product. Also, such use of improper or undesignated power cords or connection cables will void
product warranty.
30. Always leave the power O when plugging or unplugging the power cords or connection cables to
avoid electric shock or damages to the product.
31. Do NOT use any chemical such as paint thinner or benzene to clean the product’s exterior. It may
cause scratches on the surface, erasing proper indications, identication labels, or instructions on the
exterior, which may be a cause for misuse and improper operation of the product.
32. Never power wash or spray water at the front grill of the soundbar. While the speaker gaskets are
IP65 rated and won't allow ingress of water to the electrical components, doing so may cause damage
to the drivers and void the warranty.
Proposition 65 Statement
WARNING: is product can expose you to chemicals including lead which are
known to the State of California to cause cancer and birth defects or other reproduc-
tive harm. For more information, go to www.p65warnings.ca.gov
4
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be
installed and operated with minimum distance between 20cm the radiator your body: Use
only the supplied antenna.