Service manual

Latest products and information available at www.sealite.com.au

SLC300 Model

The Sealite SLC300 compact 3nm solar marine lantern is completely self-contained, and specially

designed for a range of low maintenance applications. The light boasts a large internal waterproof

battery compartment, a 20 LED flasher unit, and 4 premium-grade solar modules mounted to collect

sunlight at all angles.

In particular, the SLC300’s 2-piece design allows the lantern to be opened for convenient battery

inspection or replacement, while the base remains fixed to the supporting structure.

Installation of SLC300 Model

Lantern is activated by ON/OFF Switch. Flash setting needs to be set prior to activation.

1. Remove the wing nut from the light head and open.

2. The flash setting is set by adjusting rotary switches located in the light head. Ensure the lantern is

switched ‘OFF’ by switching toggle switch away from green sticker.

3. Remove white bung and adjust the rotary switches (A and B) to desired flash setting (see

‘Selecting a Flash Code’, below). Replace bung.

4. A sealed vent on the base allows air transfer without moisture intake, and should not be

disturbed.

5. The unit is now ready to be turned on. Switch toggle switch toward green sticker.

6. Close the light head, and replace wing nut.

7. To test place dark cover (towel or jacket) on top of light to activate sensor, light will come on.

8. Ensure that the unit is bolted to an even, flat surface.

Intensity Setting

Intensity options are available for the SLC300 model, but must be preset during manufacturing.

Selecting a Flash Code- Rotary Switches A and B

All lanterns have 2 rotary switches marked A and B on the flasher unit, as below. Turning the small

arrows to the appropriate number or letter will set the code (see ‘Flash Code’ section, page 9). The

unit may take up to one minute to activate a new flash code. A comprehensive list of available flash

codes is listed on pages 9-15 of this manual.