Service manual

Latest products and information available at www.sealite.com.au
15
SWITCH FLASH CODE ON OFF ON OFF ON OFF ON OFF
A B
MORSE CODE ( ) INDICATES LETTER
7 8 MO (A) 6 S 0.3 0.6 1.0 4.1
7 B MO (A) 8 S 0.4 0.6 2.0 5.0
8 8 MO (A) 8 S 0.8 1.2 2.4 3.6
B 8 MO (U) 10 S 0.3 0.7 0.3 0.7 0.9 7.1
C 8 MO (U) 10 S 0.4 0.6 0.4 0.6 1.2 6.8
D 8 MO (U) 10 S 0.5 0.5 0.5 0.5 1.5 6.5
9 8 MO (A) 10 S 0.5 0.5 1.5 7.5
8 9 MO (D) 10 S 5.0 1.0 1.0 1.0 1.0 1.0
A 8 MO (A) 15 S 0.5 1.5 2.0 11.0
F 8 MO (U) 15 S 0.6 0.3 0.6 0.3 1.4 11.8
0 9 MO (U) 15 S 0.7 0.5 0.7 0.5 1.9 10.7
1 9 MO (U) 15 S 0.7 0.7 0.7 0.7 2.1 10.1
7 D MO (B) 15 S 1.5 0.5 0.5 0.5 0.5 0.5 0.5 10.5
Trouble Shooting
Problem Remedy
Lantern will not activate.
• Ensure internal toggle switch is set to the 'ON position (only for
SLC300).
• Ensure lantern is in darkness.
• Wait at least 60 seconds for the program to initialise in
darkness.
• Ensure switch setting is on a valid code (not unused flash code).
• Ensure battery terminals are properly connected.
• Ensure battery voltage is above 12volts.
Timing codes will not change.
• Turn rotary switches several times to ensure contacts are clear.
Lantern will not operate for the
entire night.
• Expose lantern to direct sunlight and monitor operation for
several days. Sealite products typically require 1.5 hours of
direct sunlight per day to retain full autonomy. From a
discharged state, the lantern may require several days of
operational conditions to 'cycle' up to full autonomy.
• Reducing the light output intensity or duty cycle (flash code) will
reduce current draw on the battery.
• Ensure solar module is clean and not covered by shading during
the day.