Service manual

Latest products and information available at www.sealite.com.au

AIS Monitoring System

Assembly with SLC600 Case

Installation of the AIS Monitoring System includes the following steps:-

• Unpacking

• Initial Inspection

• Installing the AIS base unit (case)

• Assembly

Unpacking instructions

Unpack all hardware and verify all components are in accordance with Figure 4, the SLC600 system.

Please contact your Sealite office if there is any hardware missing.

Initial Inspection

Inspect all hardware for damage. If there is any damage, please contact your Sealite Office. Retain

original packing material for possible future use in shipping the AIS Monitoring System.

Assembly of the factory supplied SL125 AIS System requires the following:-

• Installation of SL125 Lantern with mounting plate/GPS Antenna

• Installation of VHF Antenna

• Wiring of Lantern and Antennae

• Installation & wiring of battery

• Assembly of SLC500/600 Case

Installation of SL125 Lantern with Mounting Plate

Tools required:

1 x 6mm Allen Key

1 x Large Flat Blade Screwdriver

1 x Small Flat Blade Screwdriver

• Remove the Flash Adjustment Plug from the base of the Lantern using the Large Flat Blade

Screwdriver. For details, please refer to the SL125 Installation Manual

• Set the Flash Code and the Intensity using a Small screwdriver. For details of the Flash Codes

tables please refer to the SL125 Installation Manual.

• Replace the Flash Adjustment Plug and secure tightly.

• Remove the 4 x M8 Socket Head Cap Screws from the mounting plate on top of the SLC600 Solar

Housing.

• Position the Sealite SL125 lantern on to the mounting plate. Remember to position the lantern with

the power cable exiting near the lantern power connector.

• Secure the Lantern using the 4 x M8 Socket Head Cap Screws.

• Remove the protective caps from both the Lantern and the Solar Panel Housing.

• Connect the Lantern and secure tightly.

Installation and Assembly Instructions