Service manual

Latest products and information available at www.sealite.com
8
SL-07 Series
1–4NM+ Marine Lanterns
Lantern is activated by the connection of positive and negative wires to battery or mains system. Flash
setting needs to be set prior to activation.
1. Remove the marked ash adjustment bung from the base of the lantern and set rotary switches to
the required ash code (see ‘Selecting a Flash Code’ section of this manual).
2. Replace ash adjustment bung.
3. A sealed vent on the base allows air transfer without moisture intake, and should not be disturbed.
4. Battery Connection: Connect “Battery Negative (-)” wire to negative terminal of battery, and
“Battery Positive (+)” wire to positive terminal of battery.
Mains Connection: Connect negative and then positive wires to 12volt power supply (ONLY).
5. To test place dark cover (towel or jacket) on top of light to activate sensor, light will come on within
one minute.
6. Ensure that the unit is bolted to an even, at surface.
Care must be taken to observe the polarity of each wire before they are connected.
Installation of SL-07 Series Models