Service manual

Latest products and information available at www.sealite.com
6
SL07, SLC310 & SLC410
Compact 3-5nm+ Solar Marine Lanterns
•
Specications subject to change or variation without notice
*
Subject to standard terms and conditions
† Intensity setting subject to solar availability
SPECIFICATIONS •
Light Characteristics
Light Source 1 LED
Available Colours Red, Green, White, Yellow, Blue
Maximum Available Intensity (cd)† Red - 121 Green - 88 White - 176 Yellow - 95
Visible Range (nm) 1-5+
Horizontal Output (degrees) 360
Vertical Divergence (degrees) 7
Available Flash Characteristics Up to 256 IALA recommended (user adjustable)
Intensity Adjustments Adjustable in 25% increments
LED Life Expectancy (hours) >100,000
Electrical Characteristics
Current Draw (mA) 120
Circuit Protection Integrated
Nominal Voltage (v) 12
Temperature Range -40 to 80°C
Physical Characteristics
Body Material LEXAN® Polycarbonate – UV-stabilised
Lens Material LEXAN® Polycarbonate – UV-stabilised
Lens Diameter (mm/inches) 98 / 3
7
/8
Lens Design Single LED Optic
Mounting 4 x 6mm mounting holes
Height (mm/inches) 141 / 5
1
/2
Width (mm/inches) 136 / 5
3
/8
Mass (kg/lbs) 0.4 /
7
/8
Product Life Expectancy Up to 12 years
Certications
CE EN61000-6-3:1997. EN61000-6-1:1997
Quality Assurance ISO9001:2008
Waterproof IP68
Intellectual Property
Trademarks SEALITE® is a registered trademark of Sealite Pty Ltd
Warranty *
3 years
Options Available
• 50mm pole mount adapter plate
• Additional cable
• Light sensor disabled
• IR Controller
• GPS Synchronisation: enable/disable
Lantern is activated by the connection of positive and negative wires to battery or mains system. Flash
setting needs to be set prior to activation.
1. Remove the marked ash adjustment bung from the base of the lantern and set rotary switches to
the required ash code (see ‘Selecting a Flash Code’ section of this manual).
2. Replace ash adjustment bung.
3. A sealed vent on the base allows air transfer without moisture intake, and should not be disturbed.
4. Battery Connection: Connect “Battery Negative (-)” wire to negative terminal of battery, and
“Battery Positive (+)” wire to positive terminal of battery.
Mains Connection: Connect negative and then positive wires to 12volt power supply (ONLY).
5. To test place dark cover (towel or jacket) on top of light to activate sensor, light will come on within
one minute.
6. Ensure that the unit is bolted to an even, at surface.
Care must be taken to observe the polarity of each wire before they are connected.
Installation of SL07 Model