Service manual

Latest products and information available at www.sealite.com
21
SL07, SLC310 & SLC410
Compact 3-5nm+ Solar Marine Lanterns
The IR remote is used to communicate with Sealite lighting products that have
an IR sensor tted. The remote control is used for the following functions:
• Flash Code: read the current ash code, congure a new ash code.
• Lamp Intensity: read the current lamp intensity, congure a new intensity
level.
• Ambient Light Thresholds: read the current light thresholds, congure new
ambient light thresholds.
• Perform a battery health check.
On receiving a valid key signal from the IR Remote, the light will ash once.
The user should wait until the light responds to each keypress before pressing
another key. If there is no response to the keypress after 3 seconds, it has not
been detected by the light and the key can be pressed again.
If an invalid key is detected, the light will ash quickly 5 times. In this case, the
command will have to be restarted.
T/CT/C
Read Lux
Flash Code Intensity Battery Status
Test / Congure
R L
FC I B
3
4 5 6
7 8 9
0
1 2
Optional IR Remote Control
SL07, SLC310 & SLC410 Models
Sealite IR Controller / Universal Remote Compatibility
If you lose your Sealite IR Controller, the following Universal Remote Controller has been tested for
compatibility: RCA Type RCR312WR programmed for Phillips TV Type Code 10054
Sealite Key Universal
Remote Key
T Power
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9
0 0
R Channel+
L Mute
FC Volume+
I Volume-
B Channel-