Installation Instructions

Steps
1. Verify the contents and accessories in the kit.
2. Connect the interfaces on the control box and light sets, and then connect them to the vehicle
power supply to verify whether the light sets work and APP can be operated by the remote
controller normally.
3. Disconnect the control box and the light sets, and secure the connecting box in place (with
cable ties).
4. Clean the position for Rock light installation and measure the locations of holes on the light
sets. Secure the light sets with screws, nuts and washers for each hole. A cable hole shall be
drilled to conceal the cables and wires.
5. Tighten the light set wires and control box outgoing wires and conceal them in a hidden place.
(Do not put them over the engine or suspensions to prevent damage.)
6. Fix the spare cables and wires of the Rock light on the side bars with cable ties (at hidden
places to prevent them from being trapped in the transmission shaft or tires).
Using the strip light with remote
Buttons
Functions
ON/OFF
Shut down, restore factory settings
RANDOM
Random switch
SOLID
Keep it on
SPEED+/SPEED-
Switching speed
BRIGHT+/BRIGHT-
Brightness increase and decrease
COLOR+/COLOR-
Switch color
MODE+/MODE-
Switch light mode
FAQs:
1. No light: Check whether the light is properly wired and the interface is tightly inserted.
2. Bluetooth connection fails: Make sure that the Bluetooth on your phone is on.
3. Compatibility error. Please replace a new phone or upgrade your phone system.
4. Keep the light sets within 2m.
5. For any questions, please contact our after-sale services.