User's Manual

Interior ambient LED strips, User Manual, model: SL9CIL19100

English 01

German 07

French 13

Spanish 19

Italian 25

Contents

LED strips

Control box

Car charger

Manual

Quick Installation

Audio Control Manual

Clip

Cable tie

Product Specifications

Light color

RGB

Power supply mode

Car charger

Voltage

12V

Control mode

App + control box

Operating temperature

-25–50℃

Before installation

1. Open the box and check the contents.

2. Plug the car charger into the cigarette lighter and check whether the LED

strip is turned on.

Steps

1. Wipe the surface of the mounting position and make sure it is clean, dry and

smooth.

2. Place the control box in the armrest box and fix wires of the LED strips with a

clip as shown below.

3. Remove the red protection film of the LED strips and paste the strip as

shown in the figure below.

4. Firmly press the whole LED strip. Fix the strip with a cable tie.

5. Plug the car charger into the cigarette lighter and the LED strip will light up. It

indicates the LED strip is powered on.

Control via control box

PAGE 1
Interior ambient LED strips, User Manual, model: SL9CIL19100 English 01 German 07 French 13 Spanish 19 Italian 25 Contents LED strips 4 Control box 1 Car charger 1 Manual 1 Quick Installation 1 Audio Control Manual 1 Clip 8 Cable tie 10 Product Specifications Light color RGB Power supply mode Car charger Voltage 12V Control mode App + control box Operating temperature -25–50℃ Before installation 1. Open the box and check the contents. 2.
PAGE 2
Buttons Functions Switch On/Off Mode Press the button to switch among 4 modes. Color/brightness Press the button to switch among eight colors and press and hold the button to switch among six levels of brightness Control via App Download the App. Download and install the App from App store (for iOS) or Google Play (for Android). Tip: The App is compatible with the following phone systems: iOS 9.0 and above, Android 5.0 and above. Connect with the App 1.
PAGE 3
try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.