Instructions

Refer to instruction
manual
Wear eye
protection
Wear protective
gloves
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
VS2005.V3 Issue:1 11/07/22
Original Language Version
© Jack Sealey Limited
DIESEL INJECTOR PULLER
CITROEN/PEUGEOT
Model no: VS2005.V3
1. SAFETY
 WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using tools.
 WARNING! Always use caution when working around fuel systems. The fuel in the fuel rail may be pressurised even if the engine is not
running.
 IMPORTANT: These instructions are provided as a guide only. Always refer to the vehicle manufacturer’s service instructions,or a
proprietary manual, to establish the current procedure and data, also any warnings or cautions particular to the vehicle.
8 DO NOT use the set if any parts are missing or damaged.
8 DO NOT use this tool for any purpose other than that for which it is designed.
9 Switch o󰀨 vehicle’s ignition and disconnect the battery before commencing work under the bonnet.
8 Never lay tools on the vehicle’s battery. This may short the terminals
together, causing harm to yourself, the tools, or the battery.
9 Operate in a well ventilated area. DO NOT inhale fuel vapours.
9 Wear approved eye protection. A full range of personal
safety equipment is available from your Sealey stockist.
9 Wear suitable clothing to avoid snagging. DO NOT wear
jewellery and tie back long hair.
9 Keep children and other unauthorised persons away from
the working area.
9 Keep yourself, tools, and test equipment away from hot engine parts.
9 Always keep a re extinguisher close by, that is suitable for
fuel/electrical/chemical res.
8 NEVER smoke or have open ames near vehicle.
9 Always relieve fuel pressure before disconnecting fuel
lines from injectors.
9 Use a rag to cover fuel line ttings, when connecting or
disconnecting fuel lines. Avoid contact with fuel.
9 Clean up all fuel spills immediately and dispose of all rags properly.
9 Maintain the tool components in good and clean condition
for best and safest performance.
9 When work on the vehicle is nished, ensure all connections
on vehicle are restored, and that there are no tools left in the
engine bay.
9 Replace tools in the carrying case and store in a safe, dry,
childproof location.
2. INTRODUCTION
Comprehensive set for removing Citroen/Peugeot 2.0/2.2HDi 16v
fuel injectors. Allows the removal of seized injectors without the need
to remove the cylinder head. Bridge ts perfectly on the cylinder head
preventing damage to the area surrounding the injector.
3. CONTENTS (g.1)
1 Bridge
2 3 x Bridge Legs
3 2 x Force Screws - Thread 17mm, 25mm x Pitch 1mm
4 Force Screw Nut
5 Injector Sockets 25mm, 29mm
6 Security Hex Key - ½”sq. drive
g.1
g.2
Wear protective
clothing
Wear protective
footwear