Manualshelf

User Manual

ManualsBrandsSealer Sales ManualsBag SealersWN Series 26" Long Hand Impulse Sealer w/ Sliding Cutter, 2.7mm Seal Width
12345678910
W H L H I N S T R U C T I O N M A N U A L
3
Safety Instructions
WARNING!
Below are general safety precautions and warnings that should be
understood prior to setting up or operating your equipment. Read and fully understand all instructions and
warnings prior to using this unit. Your safety is most important! Failure to comply with procedures may
result in serious injury or property damage. Remember:
Your personal safety is your
responsibility.
Unsafe practices or unauthorized modifications could result in accidents or property damage. Failure to
follow these safety rules and take necessary precautions can result in serious injury as well as damage to
equipment. Failure to comply with the safety instructions would also void the warranty.
Never operate or service your sealer until you have read this manual completely and understand it
fully.
Only plug the sealer into a standard 120 Volt, 60Hz wall outlet or surge protector.
Do not use the sealer if the power cord, plug or any other parts are damaged. Do not to allow the
power cord to drape into your work area. Check that all parts are operating properly and perform
the intended functions. Check for any worn parts before starting operation. Check for all other
conditions that may affect the operation of your sealer.
Reduce risk of unintentional starting. Make sure the power switch is in the "OFF" position before
attaching to the power source.
Always disconnect sealer from power source before servicing, changing accessories or cleaning the
unit.
To provide protection against the risk of electrical shock, the power connection must be properly
grounded at all times.
Do not leave the sealer unattended when in use. Disconnect the sealer from the power source
before leaving the work area.
Do not use the machine for any other purpose other than to seal thermoplastic materials. Doing
so may result in damage to the machine and injury to the operator.
While operating machinery, wear close-fitting clothing and tie back long hair to prevent any
external items from getting caught in the machine. Do not wear jewelry when operating the sealer.