User Manual

W H L H I N S T R U C T I O N M A N U A L
12
To install your replacement kit on your sealer, turn off power and unplug sealer.
Removing Worn Parts
1. Remove the heating element cover (Figure 4).
2. Loosen the screws on the PTFE cover plate (Figure 5).
Figure 4. Remove heating element cover
Figure 5. Remove PTFE cover plate
3. Lift up the PTFE cover to expose the heating element.
4. Remove the heating element by lifting off the eyelets of the heating element from the mounting
spring on both ends (Figure 6).
5. Peel off the PTFE adhesive under the heating element (Figure 7).
Figure 6. Remove heating element from mounting spring
Figure 7. Remove PTFE adhesive
Installing New Replacement Parts.
1. Remove the backing of the liner found on the PTFE adhesive.
2. Apply it to the sealer’s sealing platform. The PTFE adhesive must always extend past the sealing
platform by approximately ¼” to ½” on both ends. Bend down the excess on both ends. (The
PTFE adhesive acts a barrier between the metal body and the heating element. Never allow the
heating element to come in direct contact with the sealer’s body because it will damage the timer.)