User Manual

12
Maintenance
The following maintenance procedures should be followed to ensure the longevity of your W-Series
automatic sealer.
Inspection and Cleaning
1. Inspect your machine daily.
2. Use a clean cloth to remove any plastic residue remaining on the PTFE cloth.
3. When replacing the elements, always check the condition of the bottom PTFE tape.
4. Check the condition of the silicone rubber for wear and burns. A damaged silicone rubber will
affect the quality of the seal.
Replacement Kit Instructions
Our W-Series automatic sealers will require new heating elements and PTFE from time to time. Heating
elements will break through wear and tear. A good rule of thumb is to replace the PTFE adhesive every time
you change your heating element. The PTFE cover prevents the plastic or other thermoplastic material you
are sealing from sticking to the heating element.
Replacement kits are available from your distributor.
For single impulse automatic sealers, kits include (2) heating elements, (2) PTFE adhesives, and 1ft long roll
of PTFE cover. For replacement kit part #s, refer to your model #. **Please note that heating elements
and kits are NOT interchangeable with one another.**
W-300A
W-305A
W-3010A
W-450A
W-455A
W-4510A
W-600A
W-605A
W-6010A
W-755AA
Replacement Kit (2.7mm)
RK-12A-W-300A
RK-18A-W-450A
RK-24A-W-600A
Replacement Kit (5mm)
RK-12A5-W-305A
RK-18A5-W-455A
RK-24A5-W-605A
RK-30A5-W-755AA
Replacement Kit (10mm)
RK-12A10-W-3010A
RK-18A10-W-4510A
RK-24A10-W-6010A
Heating Element (2.7mm)
HE-12-2.7-W-300A
HE-18-2.7-W-450A
HE-24-2.7-W-600A
Heating Element (5mm)
HE-12-5-W-305A
HE-18-5-W-455A
HE-24-5-W-605A
HE-30-5-W-755AA
Heating Element (10mm)
HE-12-10-W-3010A
HE-18-10-W-4510A
HE-24-10-W-6010A
PTFE Adhesive
TA-12
TA-18
TA-24
TA-30
PTFE Cloth
TR-12-12
TR-18-12
TR-24-12
TR-30-12
Silicone Rubber (not included in RK)
SR-W-300A
SR-W-450A
SR-W-600A
SR-W-755AA